Merlin

Microchip controlled professional firing systems for fireworks

Easy work...

Firing - If you want to fire, you've to push the "G" button. It's "Get ready" and switches the firing voltage in the concrete module (or all the modules) on. Button "S" sets the firing voltage off. If the firing voltage is switched off, you can test the firing commands and watch the flashes of the cues' LEDs instead of fire anything.

Safety - for switching on you've to insert special key into the remote controller. The same connector serves for the charger.

MerlinEasy remote control

On Remote control are these controls:

Removable aerial is on standard BNC connector so you can use high-gain antenna with coaxial cable.

If you want to fire cue#1 on module B, you push button 'B' and next '1'. If you fire next cue#12 on module 'B', you push button '12'. You needn't push 'B' while you're firing on the same module.

If you need to fire the same cue on all firing modules, you can push one of the A-D buttons two times and all the yellow LEDs turns on => the command goes to all the modules together. With next pushing A-D button one times you switch this mode off.

Remote controller includes internal battery and the charger is in accesories.

remote